Builder Gel Flower Valeri № 06, 15ml

Valeri Builder Gel Flower is a collection of builder gels featuring delicate coloured dried flowers, which lend a manicure a special charm and a light, floral feel. The gels are suitable for both nail extensions and for repairing and strengthening the nail plate.

This is a low-temperature gel with a high degree of adhesion; it is firm and of medium viscosity (leaning towards thick), which means it self-levels well but does not run. The decorative flecks create a delicate design effect without the need for additional materials. It is easy to apply and holds the nail arch well.

Valeri gels are used in a three-phase system. Thanks to their comfortable consistency, they can be applied using a technique that produces no dust or only minimal dust.

Volume: 15 ml, excluding the brush.

Application technique:
1. Prepare the nail plate: remove any previous polish, mechanically prepare the nail, shape the nail and perform a manicure.
2. Degrease the nail plate using Valeri Nail Prep & Cleanser 3-in-1, then apply Valeri Dehydrator and Valeri Ultrabond.
3. Apply a base coat of Valeri Rubber Base or Valeri Cold Base to the entire nail and cure under a UV/LED lamp for 30–60 seconds.
4. Apply your chosen Valeri Builder Gel Flower using your preferred technique (extension or strengthening) and cure it under a UV/LED lamp for 60–120 seconds.
5. Buff the shape and surface as required.
6. Apply your chosen Valeri Top and cure it under a UV/LED lamp for 60–120 seconds.
7. When using Valeri Rubber Top, remove the dispersion layer 2–3 minutes after curing. If necessary, file the natural nail from the inside.

Notes:
– use original bulbs to ensure the lamp operates correctly;
– after curing, the gel may have a sticky, tacky layer, which should be removed before applying colour or a top coat;
– apply a thin layer of gel near the cuticle to prevent lifting;
– the properties of the gel depend on the ambient temperature. Please note that in winter the materials thicken, whilst in summer they become thinner.

Please note! To prevent the material from polymerising unintentionally whilst working, testing or filming, keep any open bottles or brushes away from daylight, particularly direct sunlight. Please note that even on overcast days, clouds allow enough ultraviolet radiation to pass through for the material to start curing.
Curing: under a 48 W LED/UV lamp for 60–120 seconds per layer, depending on the thickness of the application.

Precautions: For professional use only. May cause an allergic reaction. Keep away from hot surfaces, open flames and ultraviolet light. Avoid contact with the skin. Keep out of the reach of children.

Storage conditions: Store at a temperature between +15°C and +23°C.

Shelf life: 24 months.